AS 1562.3-2006

1-AS 1562.3-2006 DESIGN AND INSTALLATION OF SHEET ROOF AND WALL CLADDING - PLASTIC
4-PREFACE
5-CONTENTS
6-SECTION 1 SCOPE AND GENERAL
6-1.1 SCOPE
6-1.2 REFERENCED DOCUMENTS
8-SECTION 2 GENERAL REQUIREMENTS
8-2.1 SCOPE OF SECTION
8-2.2 MATERIAL
8-2.3 TRANSPORT, HANDLING AND STORAGE
8-2.4 SAFETY PRECAUTIONS
8-2.4.1 General
8-2.4.2 Fire precautions
8-2.4.3 Safety mesh
9-2.4.4 Walking and standing on roofs
11-SECTION 3 DESIGN OF PLASTIC ROOF AND WALL CLADDING
11-3.1 SCOPE OF SECTION
11-3.2 AGGRESSIVE ENVIRONMENTS
11-3.3 LOADINGS
11-3.3.1 Wind forces
11-3.3.2 Loadings during construction
11-3.3.3 Bracing
11-3.4 SUPPORTING STRUCTURE
12-3.5 RAFTERS, BATTENS AND PURLINS
12-3.5.1 Alignment
12-3.5.2 Width and depth
12-3.5.3 Roof pitch
12-3.6 STUDS AND NOGGINGS (DWANGS)
12-3.6.1 Alignment
12-3.6.2 Width and depth
13-3.7 FASTENERS
14-SECTION 4 INSTALLATION
14-4.1 SCOPE OF SECTION
14-4.2 ROOF AND WALL CLADDING SHEETS
14-4.2.1 General provisions
16-4.2.2 Installation of safety mesh
17-4.3 uPVC WALL CLADDING BOARDS
17-4.3.1 Application of Clause
17-4.3.2 General provisions
17-4.3.3 Handling and storage
17-4.3.4 Installation precautions
18-4.3.5 Installation
20-SECTION 5 TESTING
20-5.1 SCOPE OF SECTION
20-5.2 APPLICABILITY OF TESTS
20-5.3 RESISTANCE TO WIND FORCES
20-5.3.1 General
20-5.3.2 Resistance to wind pressures for non-cyclone regions
20-5.3.3 Resistance to wind pressures for cyclone regions
20-5.4 RESISTANCE TO IMPACT (SANDBAG) FOR ROOFING SHEET MATERIALS
20-5.4.1 General
21-5.4.2 Assessment
21-5.5 RESISTANCE TO IMPACT (SANDBAG) FOR WALL CLADDING BOARDS